1w Led Rgb 5050 Smd , AlGaInP High Voltage Led Chip 48V 54V 90V 110V

Detailed Product Description

High Quality ultraviolet 2in1 Diode SMD 5050 5054 365nm+395nm/405nm UV LED Chip for Nail Lamp

Product Description 

Product Details

LM-80 50000 Hours Tested 5050 SMD LED
size:5.0*5.0*0.8mm
1. High Lumens Output & Low Brightness Decay
2. Stable Performance & Great CCT Inity.
3. Wid Color Temperature Range
4. good raw materials
5. Taiwan Epistar, Xianmen San'an chips

Product Material

high quality led chip 5050 nail light 365+395nm led smd lights

1. 99.9% gold wire
2.Taiwan red copper holder good cooling
3.high brightness Sanan Epistar led chip
Original factory formal chip more stable
4.High refractive index silicone
 

Initial Electrical/Optical Characteristics (TA=25±5ºC)

Electrical / Optical characteristics high quality led chip 5054 0.5w 3v led smd lights

 
Reel Dimensions:

Carrier Tape Dimensions:
Loaded quantity 800 PCS Per reel.
 
Please read the following notes before using the product:
1. Over-current-proof

Customer must apply resistors for protection, otherwise slight voltage shift will cause big current change (Burn out will happen).
2. Storage
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 The LEDs should be used within a year.
2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less.
2.5 The LEDs should be used within 168 hours (7 days) after opening the package.

2.6 If the moisture adsorbent material (silica gel) has fabled away or the LEDs have exceeded the storage time, baking treatment should be performed using the following conditions. Baking treatment: 60±5℃ for 24 hours.
3. Soldering Condition
3.1 Pb-free solder temperature profile.
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
4. Soldering Iron

Each terminal is to go to the tip of soldering iron temperature less than 260℃ for 5 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful because the damage of the product is often started at the time of the hand solder.
5. Repairing

Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.